Stone engraving machine is a high-energy-efficiency stone equipment, which is widely used in the industry and is favored by customers. Mechanical failure is a headache for customers and a major factor restricting the efficiency of mechanical production. So what is the reason for the failure of the stone engraving machine? How to solve it? We will give you a detailed introduction today.China Stone CNC Machines Manufacturers
1. There is no response when starting up, the machine is out of power, the handle has no response, and no display

　　 1. Change the position of the Livihong card slot in the computer case and reinstall the software

　　 2. Whether there is a pin phenomenon in the DSP handle data connection line

　　 3. Check the output current of the power supply in the control box, and whether the wiring on the wiring board is correct and whether the aviation plug is connected correctly

　　 Whether the fuse rectifier of the main power switch of the 4 drive is damaged

Two: The machine head cannot be returned to the zero position and the engraving machine format is reduced or out of bounds

　　 1. The head cannot be returned to the zero position, the screw may be misaligned, the screw needs to be adjusted

　　 2. The travel switch is damaged

　　3. The machine head cannot be returned to the zero position and the engraving machine format is reduced or out of bounds. It may be that the "model" in the machine setting does not match the actual model.

Three: running knife

　　1. The ground wire is not installed, and static electricity occurs, which causes the knife to run off and misplace.

　　 2. The printer parameters in the software do not match the engraving machine printing parameters

4: The knife often breaks when engraving hard materials

　　 1. When engraving hard materials, you need to set different engraving parameters and use different tools according to different materials

　　2Choose the appropriate lubricant

Five: When the engraving machine starts and resets, it will beep or always good or bad limit switch

　　 1. The ejector rod cannot reach the limit switch, just correct it.

　　2. The contact of the drive line is not good, try to fix the drive line firmly.

　　 3. The limit switch line is not connected properly, just connect the line.

　　 4. The limit switch is broken, just replace it.