The new automatic stone cutting machine can separately cut the stone materials at different depths, and can process stones below 1m3, which can turn waste into treasure, greatly save stone resources and protect the environment. It can be used for various types of stone materials. Mechanical cutting processing, high processing efficiency, combined with the effective use of small stone, making production costs lower.
The main advantages of the new automatic stone cutting machine:
(1) Simple operation, environmental protection, clean, convenient, professional, accurate, high quality and high efficiency.
(2) It can cut all kinds of ceramic tiles, wall tiles, floor tiles, three-dimensional bricks, ceramic plates, vitrified porcelain bricks and flat glass.
(3) The stone cutting machine can not only cut smoothly, but also improve the efficiency by more than 5 times, the life of the cutter wheel is extended by 2~4 times, the cutting edge is neat, the cost is low, no noise, light weight, convenient to use and carry, so it is deeply popular. The builder is welcome.
New automatic stone cutting machine safety operation procedures:
1. Do not operate the cutting machine without mastering the operation skills through training. To operate with permission from the custodian, and to have someone to guide and supervise.
2. Labor insurance should be fully worn before work, cuffs and plackets should be tight. Safety glasses must be worn to prevent eye damage from eye damage.
3. Check that all mechanical parts (such as saw blades, countertops, screws, chains, motors, switch buttons, etc.) are normal before working. If problems are found, they should be reported to the repair team for repairs.
4. Saw blades with cracks, unevenness, missing teeth and blunt teeth cannot be used. When replacing the saw blade, the power must be cut off. The saw blade should be installed firmly and perpendicular to the center line of the shaft. There must be no jumping when running.
5. Check that the protective baffle is complete and effective and must not be arbitrarily removed. Active protective barriers must not be moved at will.
6. After running the machine, run the machine idling for 2-3 minutes to check whether the operation of the saw blade is normal. Whether it is a test machine or a normal use, the blade is not allowed to straighten to the saw blade when the saw blade is running. At the same time, the test machine observes whether the supply of cooling water is normal.